Honda CBR 500 Riders Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Hi guys, does anyone have any tips or instructions on how should i put the pitbull trs pins and handle onto my bike

I have installed the cup in the rear axle but for my the life of me i cannot figure out how to inset the pins into the cup and over the axle on the right hand side (which one goes first)?? Whats the strategy here?

I am sure i am doing something really stupid, can someone please knock some sense in my head

This was so easy with a hollow axle :)

Sent from my SM-N976V using Tapatalk
 

·
Registered
Joined
·
12 Posts
Discussion Starter #3
Figured it out - sometimes the best thing to do is to take a break when you are tired and then start fresh later

Basically it was really simple

Put the right pin over the axle nut first, then secure it with the safety pin

You will have a lot if play and room to slide on the left side, rotate and adjust as necessary and then secure with both safety pins

Needless to say the pins needs to be mounted on the stand and things will go a lot more smoother if you are holding the stand up slightly



Sent from my SM-N976V using Tapatalk
 
1 - 3 of 3 Posts
Top