Honda CBR 500 Riders Forum banner

1 - 2 of 2 Posts

·
Premium Member
Joined
·
9 Posts
Discussion Starter #1 (Edited)
Ok,,

I've never has some much difficulty adjusting my my clutch in the past. However; When I down shift to 3, 2, or 1'st gear I with the clutch disengage I can feel the bike tugging like the clutch isn't fully disengaging to roll as in 'N'.. I've also lately been missing 2 and finding 'N' instead... I've attached a video and some pictures and any input would be appreciated..

The '15 CBR500RA has 17,000 miles on it and I don't know if anything has been done with previous owner...

I hope i just have my head up my a** and I'm not adjusting it correctly, if so any input is very welcome...

Thanks,

GazoMaker


View attachment 72529 View attachment 72530 View attachment 72531
 

·
Registered
Joined
·
3 Posts
You could have the cable routed incorrectly, one of my bikes was wrong from the factory, usual tight spot is around the head stock, start by removing the lever from the cable, check pivot pin and cable, it could be starting to fray, then check the routing of the cable is as per the owners manual
 
1 - 2 of 2 Posts
Top