Honda CBR 500 Riders Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello!
So when installing some frame sliders on my 2014 cbr500r I accidentally took this bolt out (see pic) instead of the engine mount bolt next to it. When it came out and was slotted on the end I immediately realized it was the wrong one. I saw there was a sharpie mark on it which i figure is used for torquing or some specific orientation but am not quite sure if its how it was before removal now. Curious if its something to do with how the bike runs and needs to be in the right orientation or just tightened properly and if its not will I damage my bike by starting it with it being incorrect 😬Thanks for any info. I'll keep searching to try and find out about it but figured maybe someone made my same mistake here and knows already.🙃🤦‍♂️
72328


Jlethal
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
Yea, thanks for the confirmation Tothezenith. I also came across a recall about them apparently for the 2013's I think. Knowing what it is/does helps, wasn't gonna power back up until I researched more about it.
 
1 - 4 of 4 Posts
Top