fairly sure the speed signal is analogue.
The plug is a b**ch to get to, between the airbox and the top of the gearbox. It's a 4pin, had 4 wires so assume all pins used.
I installed the Speedo Healer v4 on mine just the other month. Other than getting to the plug, the rest of the install and calibration was easy as.
Thanks for the info - made my own speed corrector with an Arduino Nano :nerd: so needed to know the type of plug used. Do you know which side is the male/female?
In case you have your project posted on github or anywhere else I'd highly appreciate if you'd post a link here. Or in fact any info would be appreciated.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Honda CBR 500 Riders Forum
159.1K posts
17.6K members
Since 2012
A forum community dedicated to Honda CBR owners and enthusiasts. Come join the discussion about performance, troubleshooting, racing, maintenance, modifications, classifieds, and more!